An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:
* Maximum performance and availability is required between the physical and virtual network.
*Load Balancing service is required for back-end web servers.
* NAT is required.
Which should the architect include in their design?

• A. Deploy an Active/Passive Tier-0 gateway and configure ECMP.
• B. Create two separate VLANs to connect the Tier-0 gateway upstream traffic and configure ECMP.
• C. Deploy an Active/Active Tier-0 gateway and configure ECMP.
• D. Deploy a Tler-1 gateway and connect It to an Active/Active Tier-0 gateway with ECMP configured.

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
This information was gathered during the Assessment Phase:
* There Isn't much budget available for a newoff-shore site.
* The new site is decentralized and no communication with the main data center is required.
* The design will need to cater for availability, upgrades, and failure scenarios.
Which three should the architect recommend In their design? (Choose three.)

• A. Install a minimum of 6 ESXi hosts in the site.
• B. Make allpNICs part of N-VDS and VMKs will be migrated.
• C. A Shared Edge/Management cluster and one for Compute.
• D. Collapse the Management/Edge/Compute cluster.
• E. Install a minimum 4 ESXi hosts In the site.
• F. Separate the hosts physical NICs for VSS and N-VDS.

Which two VMware recommendations should an architect follow when configuring top of rack (ToR) switches in an NSX-T Data Center environment? (Choose two.)

• A. Modify the Spanning Tree Protocol to increase the time to transition to the forwarding state.
• B. Use only IPv4 addressing in all deployments.
• C. Configure switch ports that connect to ESXi host manually as trunk ports.
• D. Configure switch ports with a Dynamic Trunking Protocol.
• E. Configure redundant physical switches to enhance availability.

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:
* Customer currently has a single 10 host vSphere cluster.
* Customer wants to improve network security and automation.
* Current cluster utilization and business policies prevent changing the existing vSphere deployment.
* High-availability is important to the customer.
Which three should the architect include in their design? (Choose three.)

• A. Apply vSphere DRS VM-Host anti-affinity rules to the virtual machines of the NSX-T Edge cluster.
• B. Apply vSphere Distributed Resource Scheduler (vSphere DRS) VM-Host anti-affinity rules to NSX Managers.
• C. Deploy at least two large-size NSX-T Edge virtual machines in the vSphere cluster.
• D. Deploy the NSX Controllers in the management cluster.
• E. Apply vSphere DRS VM-Host affinity rules to the NSX-T Controller VMs.
• F. Remove 2 hosts from the cluster and create a new edge cluster.

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
During discussions about Centralized Services NAT running on Tier-1 or Tier-0 LR the customer made these requests:
* Services contain stateful services.
* Services should be in high availability mode.
Which two should the architect include in their design? (Choose two.)

• A. Mix stateful and stateless NAT rules on the same LR.
• B. NAT should be applied on the uplink Interface.
• C. An active/active model should be used.
• D. Use only DNAT rules in stateful NAT.
• E. The high availability mode supported is only Active-Stand by.