[Full-Version] 2025 New D-PDC-DY-23 Actual Exam Dumps, EMC Practice Test
Study HIGH Quality D-PDC-DY-23 Free Study Guides and Exams Tutorials
NEW QUESTION # 103
Which router types are contained in a single-area OSPF implementation?
- A. Stub router and ABR
- B. Internal router and ASBR
- C. ABR and ASBR
- D. Backbone router and Internal router
Answer: D
NEW QUESTION # 104
Refer to the exhibit:
A default route exists on OS10-C that points all Internet traffic towards 10.0.13.3 on OS10-B. A network administrator must re-route Internet traffic that is only sourced from Host-1 to 10.0.12.2 on OS10-A instead.
What feature can the administrator implement to accomplish this goal?
- A. OSPF Cost Manipulation
- B. Policy-Based Routing
- C. Source-Based Routing
Answer: A
NEW QUESTION # 105
What is the range of values that can be used when using the vlt-port-channel command?
- A. 1-512
- B. 1-256
- C. 1-1024
- D. 1-128
Answer: C
NEW QUESTION # 106
Which user role in OS10 has full access to all commands and exclusive access to commands that manipulate the file system?
- A. secadmin
- B. netadmin
- C. netoperator
- D. sysadmin
Answer: D
NEW QUESTION # 107
Which command can be used to enable SSH access to an OS10 switch?
- A. no ip ssh server disable
- B. ip ssh server enable
- C. no ip telnet disable
- D. ip mgmt ssh enable
Answer: B
NEW QUESTION # 108
There is a spanning tree mismatch at the global level. PVST+ is configured on a VLT peer. All VLT port channels go down on both VLT peers. A syslog error message is generated.
What is the correct action to resolve the issue?
- A. Enable RSTP on both VLT peers.
- B. Verify the VLT LAG ID is configured correctly on both VLT peers.
- C. Perform a mismatch check after the VLT peer is established.
- D. Use the show VLT detail and show VLT brief commands to view the VLT port channel status information.
Answer: A
NEW QUESTION # 109
Which two statements describe the operation of VRRP? (Select 2)
- A. VRRP cannot be implemented in load balancing unless using VLT.
- B. VRKP participants share the same virtual MAC and virtual IP.
- C. VRRP is a first hop redundancy protocol associating a virtual IP with a '//ell-known virtual MAC.
- D. VRRP is interoperable with other non-proprietary load-balancing protocols like CARP.
- E. VRRP can provide redundancy with up to four switches participating in a group.
Answer: B
NEW QUESTION # 110
A network administrator has recently configured eBGP to use source addressing from its loopback interfaces. Customers later report that eBGP routes are not being learned.
What could be the cause of this issue?
- A. BGP devices must be configured with the multihop command when using loopback interfaces
- B. BGPv4 does not support the use of loopback interfaces
- C. The network administrator neglected to issue the no shutdown command to bring the loopback interface online
- D. BGP devices must be configured to use source addressing from its physical interfaces only
Answer: A
NEW QUESTION # 111
When installing OS10 on a switch from a USB drive, what format is used for the file system?
- A. HFS
- B. FAT32
- C. HFS+
- D. NTFS
Answer: B
NEW QUESTION # 112
Which multicast address do all OSPF routers use?
- A. 224.0.0.5
- B. 224.0.0.6
- C. 239.0.0.4
- D. 239.0.0.6
Answer: A
NEW QUESTION # 113
A network administrator is required to group the three upper COS values. The administrator creates a trust map named dot1p-trust-map.
Which command groups the required packets in this trust map?
- A. OS10 (config-tmag-dot1p-map) # qos-group 5 dot1p 5-7
- B. OS10 (config-tmap-dscp-map) # qos-group 5 dot1p 5-7
- C. OS10 (config-tmap-dscp-map) # qos-group 5 dot1p 16-30
- D. OS10 (config-tmap-dot1p-map) # qos-group 3 dot1p 0-4
Answer: B
NEW QUESTION # 114
An administrator is implementing VLT in OS10.
What type of port-channel must they configure for the VLTi?
- A. Trunking and one (1) native VLAN need to be defined on the port-channel.
- B. Administrator needs to configure a LACP Port-Channel.
- C. None, a port-channel is created automatically during VLT discovery.
- D. Administrator needs to configure a static Port-Channel.
Answer: C
NEW QUESTION # 115
What is required to enable ECMP in BGP?
- A. Sub-interfaces must be configured on the physical interface running BGP.
- B. Maximum-paths and multipath-relax commands.
- C. ECMP is not possible in BGP.
- D. OSPF must install equal cost paths in the routing table for BGP use ECMP.
Answer: B
NEW QUESTION # 116
What version of IGMP is required by PIM-SSM receivers?
- A. IGMP 2
- B. IGMP 1
- C. IGMP 3
- D. IGMP snooping
Answer: C
NEW QUESTION # 117
Which two statements are true regarding VRF? (Select 2)
- A. By default, all the front panel ports and logical interfaces are part of the non-default VRF instance.
- B. The control and data plane are not isolated in each virtual router (VR) so that traffic flows across VRs.
- C. The control and data plane are isolated in each virtual router (VR) so that traffic does not flow across VRs.
- D. OS10 supports a management VRF instance, a default VRF instance, and up to 4096 non-default VRF instances.
- E. By default, all the front panel ports and logical interfaces are part of the default VRF instance.
Answer: C,E
NEW QUESTION # 118
An administrator wants to create a configuration that is not immediately active in the running configuration until a batch commit command is entered.
Which command will allow this process?
- A. 0S10(config)# start candidate
- B. 0S10# start transaction
- C. 0S10# start candidate
- D. 0S10(config)# start transaction
Answer: B
NEW QUESTION # 119
A company wants to document the steps that are needed for their upcoming deployment that are required to configure a single logical L2 domain from the perspective of attached devices that are terminating on separate nodes.
What three steps are recommended to meet these requirements? (Select 3)
- A. Configure virtual IP addresses.
- B. Configure the discovery-interface.
- C. Create a virtual router.
- D. Configure the VLT heartbeat.
- E. Configure VLT port channel.
Answer: A,D,E
NEW QUESTION # 120
To ensure that PIM traffic is not dropped by a router what command must be run?
- A. OS10 (config) # ip multicast permit
- B. OS10 (config) # ip multicast cast-routing
- C. OS10 (config) # ip pim sparse-made
- D. OS10 (config) # ip pim rp-address <IP address> group-address <group address>
Answer: C
NEW QUESTION # 121
What is a benefit of multicast over unicast and broadcast communication
- A. Increase of the network load
- B. Minimum network bandwidth use
- C. Latency is mitigated
- D. Bandwidth equally distributed to all devices
Answer: B
NEW QUESTION # 122
A network administrator has configured Policy-based-Routing and applied it on interface ethernet
1/1/3.
What command can be used to verify that the policy is applied?
- A. show ip policy brief
- B. show ip policy
- C. show interface ethernet 1/1/3 policy-map
- D. show ip policy map
Answer: B
NEW QUESTION # 123
......
Get 100% Real Free Dell Networking D-PDC-DY-23 Sample Questions: https://www.exam4pdf.com/D-PDC-DY-23-dumps-torrent.html
Download EMC D-PDC-DY-23 Exam Dumps to Pass Exam Easily: https://drive.google.com/open?id=1Sx-cvBQbW-YUYIqx8O2vrYIHJ-x7yhhx
