Authentic Cisco 300-610 Exam Dumps PDF - Mar-2024 Updated
300-610 Dumps Special Discount for limited time Try FOR FREE
Cisco 300-610 certification exam is important for IT professionals because it provides validation of their ability to design, deploy and manage complex data center infrastructures. Successful completion of the certification is proof that the professional has the ability to handle the latest data center technologies and can provide effective solutions that meet the demands of business. Designing Cisco Data Center Infrastructure certification can also enhance the professional’s career by increasing opportunities for promotion and higher salaries.
Cisco 300-610 exam is an essential certification exam for anyone interested in designing Cisco Data Center Infrastructure. Passing 300-610 exam will not only increase your knowledge in this area but also give you a competitive edge in the job market. Therefore, if you are interested in becoming a Cisco Data Center Infrastructure expert, take the time to prepare thoroughly and take the exam confidently.
NEW QUESTION # 34
The user traffic destined to all web servers located in the data center must pass first through a set of firewalls for deep packet inspection. A network architect must design the Cisco Intelligent Traffic Director (ITD) deployment that meets these requirements:
The firewalls are connected to a set of two Cisco Nexus switches to provide stateful handling of traffic.
The ITD service is provided for inside and outside segments of the firewall.
Which ITD deployment mode must be implemented to meet these requirements?
- A. server vPC deployment mode
- B. sandwich deployment mode
- C. server load-balancing deployment mode
- D. one-arm deployment mode
Answer: A
NEW QUESTION # 35
What can be implemented on Cisco Nexus 5600 Series Switches for link redundancy within a Fibre Channel fabric?
- A. vPC+
- B. E-Trunk
- C. SAN port channel
- D. LACP port channel
Answer: D
NEW QUESTION # 36
An engineer is implementing a Cisco UCS environment. The system must aggregate all vNICs into a single policy and consistently enforce node disassociation across the cluster. Which two UCS policies meet these requirements? (Choose two.)
- A. scrub policy
- B. LAN connectivity policy
- C. firmware policy
- D. vNIC policy
- E. boot policy
Answer: B,D
NEW QUESTION # 37
An engineer installs a B-Series server in a Cisco UCS chassis that contains a pair of UCS-IOM-2208XP I/O modules. The full bandwidth of the I/O module must be utilized.
Which two elements should be used in this environment? (Choose two.)
- A. Cisco UCS VIC 1280
- B. Cisco UCS M81KR
- C. four twinax cables from each I/O module to each fabric interconnect
- D. eight twinax cables from each I/O module to each fabric interconnect
- E. Cisco UCS VIC 1225
Answer: A,D
NEW QUESTION # 38
An engineer must design a multitenant solution using Cisco 7709 switches. The solution must support separate routing instances, separate spanning tree domains, and separate firewalls for each tenant. Which solution meets these requirements?
- A. vPC
- B. CFS
- C. VRF
- D. VDC
Answer: D
NEW QUESTION # 39
Which two features are provided by deploying an OOB management network in a Cisco Nexus data center?
(Choose two.)
- A. Layer 2 path for server traffic
- B. Layer 3 path for vPC keepalive packets
- C. Layer 3 path for server traffic
- D. Layer 2 path for a vPC peer link
- E. Layer 3 path for monitoring purposes
Answer: A,D
NEW QUESTION # 40
A company must integrate an iSCSI storage solution into its existing production environment. The new iSCSI network must be accessible from a limited set of network segments. The client devices follow a strict network security policy to access critical data from the storage array. Which design steps must be used to meet these requirements?
- A. Option D
- B. Option C
- C. Option A
- D. Option B
Answer: B
NEW QUESTION # 41
A customer needs a design for a new data center network that meets these requirements:
Logically partition the environment into separate security domains.
Cut costs related to purchasing additional equipment.
Separate routing processes, TCAM, QoS tables, and data planes.
Which technology must be used?
- A. VLAN
- B. vPC
- C. VRF
- D. VDC
Answer: D
NEW QUESTION # 42
Refer to the exhibit.
The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?
- A. 2000 bytes
- B. 2158 bytes
- C. 9000 bytes
- D. 2240 bytes
Answer: A
Explanation:
This policy map shows a wrong MTU config. Check "12. Do I need to enable Jumbo frames for FCOE?" in https://community.cisco.com/t5/data-center-documents/fibre-channel-over-ethernet-fcoe-questions-and-answers-from-live/ta-p/3108755
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/qos/521_n1_1/b_5k_QoS_Config_521N11/b_5k_QoS_Config_521N11_chapter_0110.html
NEW QUESTION # 43
A failure occurs on the network between two BFD and OSPF neighbors. Drag and drop the protocol actions from the left into the correct order on the right.
Answer:
Explanation:
NEW QUESTION # 44
Refer to the exhibit.
What must be the default gateway of the servers in EPG Web?
- A. subnet address of BD1
- B. subnet address of BD2
- C. subnet address of L3Out
- D. NAT appliance
Answer: D
NEW QUESTION # 45
A customer needs to deploy a three-tier network architecture that will consist of web, app, and other businesscritical applications. The solution will include Cisco UCS 6324 Fabric Interconnects managing B and C series servers. The fabric interconnects will be connected to the Cisco Nexus 7706 Series Switch for network access.
A storage array will be directly connected to the UCS fabric interconnects.
Which UCS deployment type must be used to meet these requirements?
- A. UCS interconnect in Ethernet switching mode
UCS interconnect in Fibre Channel switching mode
Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in passive mode - B. UCS interconnect in Ethernet switching mode
UCS interconnect in Fibre Channel end-host mode
Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in active mode - C. UCS interconnect in Ethernet end-host mode
UCS interconnect in Fibre Channel switching mode
Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in active mode - D. UCS interconnect in Ethernet end-host mode
UCS interconnect in Fibre Channel end-host mode
Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in passive mode
Answer: B
NEW QUESTION # 46
What is the disadvantage of asynchronous storage replication as compared to synchronous storage replication in a disaster recovery design?
- A. specific backup requirements
- B. reduction in application performance
- C. distance limitations
- D. potential data loss
Answer: D
NEW QUESTION # 47
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?
- A. NPIV mode
- B. NPV mode
- C. FC switching mode
- D. FC end-host mode
Answer: C
Explanation:
Section: Storage Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/ Storage-Mgmt/3-1/b_UCSM_GUI_Storage_Management_Guide_3_1/ b_UCSM_GUI_Storage_Management_Guide_3_1_chapter_01110.html
NEW QUESTION # 48
Refer to the exhibit.
A high-availability setup for iSCSI is designed with the host running ISCSI software. Each storage port on the MDS exports the same two Fibre Channel target ports with different ISCSI target names. In this design, how many ISCSI session are created from the host so that recovery occurs if any component fails?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
Explanation:
Reference:
NEW QUESTION # 49
......
300-610 Dumps for success in Actual Exam: https://www.exam4pdf.com/300-610-dumps-torrent.html
Realistic 300-610 100% Pass Guaranteed Download Exam Q&A: https://drive.google.com/open?id=1tb_-lxpGiyBemBfFtdAHsd8pjLyn1s7U
